Keysight N6705C - Page 344

[SOURce:]VOLTage:LIMit[:POSitive][:IMMediate][:AMPLitude] <value> , (@<chanlist>)
[SOURce:]VOLTage:LIMit[:POSitive][:IMMediate][:AMPLitude]? [MIN|MAX,] (@<chanlist>)
[SOURce:]VOLTage:LIMit:NEGative[:IMMediate][:AMPLitude] <value>, (@<chanlist>)
[SOURce:]VOLTage:LIMit:NEGative[:IMMediate][:AMPLitude]? [MIN|MAX,] (@<chanlist>)
Sets the voltage limit when in current priority mode. Units are in volts. The maximum value depends
on the voltage rating of the unit. The minimum value is the most negative value.
Parameter Typical Return
Positive: 0 to 102% of rating|MIN|MAX, *RST 102%
Negative: -102% of rating to 0|MIN|MAX, *RST -102%
<+ voltage limit>
<- voltagelimit>
Sets the positive voltagelimit to 20.4 V: VOLT:LIM 20, (@1)
Sets the negative voltage limitto -20.4 V: VOLT:LIM:NEG -20, (@1)
l MIN refers to the most negative value of the range. MAX refers to the least negative value of the
range.
l The query returns the programmed voltage limit in the form +n.nnnnnnE+nn for each channel spe-
cified. Multiple responses are separated by commas.
[SOURce:]VOLTage:LIMit:COUPle 0|OFF|1|ON, (@<chanlist>)
[SOURce:]VOLTage:LIMit:COUPle? (@<chanlist>)
Sets the voltage limit tracking state. The negative voltage limit tracks the positive voltage limit
setting.
Parameter Typical Return
0|OFF|1|ON, *RST OFF 0or1
Enables the voltage limittracking state: VOLT:LIM:COUPON, (@1)
[SOURce:]VOLTage:MODE FIXed|STEP|LIST|ARB, (@<chanlist>)
[SOURce:]VOLTage:MODE? (@<chanlist>)
Sets the transient mode. This determines what happens to the output voltage when the transient
system is initiated and triggered.
FIXed - keeps the output voltage at its immediate value.
STEP - steps the output to the triggered level when a trigger occurs.
LIST - causes the output to follow the list values when a trigger occurs.
ARB - causes the output to follow the arbitrary waveform values when a trigger occurs.
7 SCPI Programming Reference
344 Keysight N6705C Operating and Service Guide