Parameter Typical Return
FIXed|STEP|LIST|ARB, *RST FIXed FIX, STEP, LIST, or ARB
Sets the voltagemode to Step: VOLT:MODE STEP, (@1)
[SOURce:]VOLTage:PROTection[:LEVel] <value>, (@<chanlist>)
[SOURce:]VOLTage:PROTection[:LEVel]? [MIN|MAX,] (@<chanlist>)
This command does NOT apply to models N678xA SMU. Refer to
[SOURce;]VOLTage:PROTection:REMote and
[SOURce:]VOLTage:PROTection:REMote:NEGative.
Sets the over-voltage protection level.Units are in volts.
If the output voltage exceeds the OVP level, the output is disabled and the Questionable Condition
status register OV bit is set.
Parameter Typical Return
0 – maximum|MIN|MAX, *RST MAX
The maximum value is 120% of the voltage rating of
the power module.
<over-voltage level>
Sets the over-voltageprotection to 60 V: VOLT:PROT 60, (@1)
l An over-voltage condition can be cleared with the OUTput:PROTection:CLEar command after the
cause of the condition has been removed.
l The query returns the programmed voltage protection level in the form +n.nnnnnnE+nn for each
channel specified. Multiple responses are separated by commas.
[SOURce:]VOLTage:PROTection:DELay[:TIME] <value>, (@<chanlist>)
[SOURce:]VOLTage:PROTection:DELay[:TIME]? [MIN|MAX,] (@<chanlist>)
Sets the over-voltage protection delay. The over-voltage protection function will not be triggered
during the delay time. After the delay time has expired, the over-voltage protection function will be
active. This prevents momentary changes in output status from triggering the over-voltage protection
function. Programmed values can range from 60 microseconds to 5 milliseconds with a resolution of
20.48 microseconds.
Parameter Typical Return
60 μs - 5 ms | MIN | MAX, *RST 0 <delay value>
Sets the protection delay to 1 millisecond: VOLT:PROT:DEL 0.001, (@1)
Keysight N6705C Operating and Service Guide 345
7 SCPI Programming Reference
To Next Page
Loading...
