To Next Page

To Previous Page

3 VMA Mode

3.9 SEM Measurement

Preset Automatically calculated

LTEAFDD, LTEATDD, 5G NR, MSR Modes:

ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON|

ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON

When the max number of offsets is 14:

WLAN Mode:

ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON

All Other Modes:

When the max number of offsets is 6:

ON,ON,ON,ON,ON,ON

When the max number of offsets is 12:

ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON

State Saved Saved in instrument state

Range Auto|Man

Offset Side

Specifies which offset side to measure.

You can turn off (not use) specific offsets with [:SENSe]:SEMask:OFFSet[n]

[:OUTer]:LIST:STATe.

BOTH

Both of the negative (lower) and positive (upper) sidebands

NEGative

Negative (lower) sideband only

POSitive

Positive (upper) sideband only

When sending the remote command, missing values are not permitted; that is, if you

want to change values 2 and 6, you must send all values up to 6. Subsequent values

remain unchanged. The query returns 14 values for WLAN Mode, and 12 values for

other Modes.

The figure below shows the relation between the negative/positive offset side setups

and the upper/lower results in the MSR, LTE-Advanced FDD/TDD and 5G NR

Modes.

1505 Vector Modulation Analyzer Mode User's &Programmer's Reference

Keysight N9010B Programmer's Reference

Other manuals for Keysight N9010B