Keysight N9010B - 10.2.17 Resolution Bandwidth; 10.2.18 Trigger Delay; 10.2.19 Trigger Level; 10.2.20 Trigger Slope

10 Hardware-Accelerated Fast Power Measurement (Remote Command Only)
10.2 Reset Fast Power Measurement (Remote Command Only)
10.2.17 Resolution Bandwidth
Example
:CALC:FPOW:POW1:DEF "ResolutionBW=25e3"
Notes Sets the 3-dB bandwidth of the RBW filter. "Resolution Bandwidth Mode" on page 2637 must be set to
Explicit to manually set the RBW
Preset 0 Hz
10.2.18 Trigger Delay
Example
:CALC:FPOW:POW1:DEF "TriggerDelay=0.025"
Notes Sets the time after an external trigger is detected until the measurement is performed
Preset 0 s
Range 0 – 1 s
10.2.19 Trigger Level
Example
:CALC:FPOW:POW1:DEF "TriggerLevel=2"
Notes Sets the voltage value at which an external trigger is detected
Preset 1.2 V
Range -5 to 5 V
10.2.20 Trigger Slope
Example
:CALC:FPOW:POW1:DEF "TriggerSlope=Negative"
Notes Specifies the direction of the edge trigger voltage for detection
Preset
Positive
Range
Positive, Negative
10.2.21 Trigger Source
Example
:CALC:FPOW:POW1:DEF "TriggerSource=Ext1"
Notes Lets you select whether the measurement triggers freely, or is controlled by an external input
Ext1 and Ext2 correspond to Trigger 1 In and Trigger 2 In, respectively
Preset
Free
Range
Free, Ext1, Ext2
2638 Vector Modulation Analyzer Mode User's &Programmer's Reference