7 Save/Recall/Print
7.3 Save
–
The FILLed theme is an exact representation of the information on the display
–
The OUTLine theme eliminates most of the filled areas, in order to save ink
when the image is printed. In addition, the yellow trace color is changed to be
more orange, to improve visibility against a white background. Note that some
objects remain filled. In particular, the selected marker remains filled with the
green marker color, in order to distinguish it from the other markers. This is
important, as it is the selected marker whose readout appears in the upper right
corner of the display
7.3.69 Power Sensor Cal Factor
Selects a file to which to export the Power Sensor Cal factor data.
Cal Factor files are XML files, and contain the cal factor data and header data that
gives information on the power sensor.
The default path for Cal Factor Files is:
My Documents\<mode name>\data\PSCF
where <mode name> is the parameter used to select the mode with :INST:SEL (for
example, MRECEIVE for Measuring Receiver Mode). Hence, a Cal Factor file from any
measurement in the Measuring Receiver mode would be stored in:
My Documents\MRECEIVE\data\PSCF
Cal Factor files have the extension .xml. The default filename is <Sensor Model>_
<Sensor Serial Number>_0000.xml, where the 4-digit number is the lowest
number that does not conflict with any filename in the current directory. If the
sensor model or serial number is blank, the default filename is PSCF_0000.xml.
Remote Command
:MMEMory:STORe:PSCFactor <file_name>
Example
:MMEM:STOR:PSCF "myPSCF.xml"
Notes If the save is initiated via SCPI, and the file already exists, the file will be overwritten
Using the C: drive is strongly discouraged, since it runs the risk of being overwritten during an
instrument software upgrade
Both single and double quotes are supported for any filename parameter over SCPI
Dependencies Only appears if you have the proper option installed in your instrument
7.3.70 Recording
Lets you save to a file data being acquired by the measurement, so that it can later
be recalled and played back as though it were coming from the input.
You may specify a data type (for example, I/Q data) and choose a file to which to
save the data.
2420 Vector Modulation Analyzer Mode User's &Programmer's Reference
To Next Page
Loading...
