Keysight N9010B Programmer's Reference

9 Programming the Instrument
9.4 Status Register System & STATus Subsystem
Questionable Calibration Extended Needed Event Query
Returns the decimal value of the sum of the bits in the Questionable Calibration
Extended Needed Event register.
NOTE
The register requires that the associated PTRansition or NTRansition filters be
set before a condition register bit can set a bit in the event register. The data in
this register is latched until it is queried. Once queried, the register is cleared.
Remote
Command
:STATus:QUEStionable:CALibration:EXTended:NEEDed[:EVENt]?
Example
:STAT:QUES:CAL:EXT:NEED?
Preset 0
Status Bits/OPC
dependencies
Sequential command
Questionable Calibration Extended Needed Negative Transition
Determines which bits in the "Questionable Calibration Extended Needed Condition"
on page 2609 register will set the corresponding bit in the "Questionable Calibration
Extended Needed Event Query" on page 2610 register when the condition register
bit has a negative transition (1 to 0).
The variable <integer> is the sum of the decimal values of the bits that you want to
enable.
Remote
Command
:STATus:QUEStionable:CALibration:EXTended:NEEDed:NTRansition <integer>
:STATus:QUEStionable:CALibration:EXTended:NEEDed:NTRansition?
Example
:STAT:QUES:CAL:EXT:NEED:NTR 2
Conducted alignment required bit being cleared will be reported
Preset 0
Min 0
Max 32767
Status Bits/OPC
dependencies
Sequential command
Questionable Calibration Extended Needed Positive Transition
Determines which bits in the "Questionable Calibration Extended Needed Condition"
on page 2609 register will set the corresponding bit in the "Questionable Calibration
Vector Modulation Analyzer Mode User's &Programmer's Reference 2610

Keysight N9010B Specifications

General

Brand	Keysight
Model	N9010B
Category	Measuring Instruments
Language	English