3 VMA Mode
3.9 SEM Measurement
Remote
Command
[:SENSe]:SEMask:CARRier:PEAK[:POWer] <real>
[:SENSe]:SEMask:CARRier:PEAK[:POWer]?
Example
:SEM:CARR:PEAK -80
:SEM:CARR:PEAK:POWER?
Notes Although the default value is defined, the value is recalculated by the measurement result just after
completing the measurement
Carrier sub op code. 1 for BTS, 2 for MS. Default is BTS
Couplings Coupled with "Measurement Type" on page 1559. Active when Measurement Type is "Spectrum Peak
Ref". Otherwise, grayed-out
In MSR, LTE-A and 5G NR Modes, active when Measurement Type is Spectrum Peak Ref and Power Ref
is Manual
Preset Measured carrier Spectrum Peak reference power
State Saved Saved in instrument state
Min/Max -200/200
Annotation Value is displayed on the right top of the Results window. If Meas Type selection is Spectrum Peak Ref,
the string is “Spectrum Peak Ref” with BOLD font, otherwise, hide annotation
Measure All Ref Carriers
When ON, all reference carriers configured are always measured irrespective of
Measure Carrier on/off settings.
Remote Command
[:SENSe]:SEMask:CARRier:MEASure:ALL ON | OFF | 1 | 0
[:SENSe]:SEMask:CARRier:MEASure:ALL?
Example
:SEM:CARR:MEAS:ALL 1
:SEM:CARR:MEAS:ALL?
Dependencies Only available in MSR, LTE-A and 5G NR Modes
Preset 0
State Saved Saved in instrument state
Offset/Limits Config Table
This function is the same as "Offset/Limits Config Table" on page 1481 under the
"Settings" on page 1475 tab.
Sets the power reference in the carrier that will be used to compute the relative
values for the offsets.
3.9.18.4 Advanced
Contains controls for setting advanced instrument functions.
Vector Modulation Analyzer Mode User's &Programmer's Reference 1568
To Next Page
Loading...
