Keysight N9010B - 4.6.2.1 Align Now All

4 System
4.6 Alignments
–
"Align Now All" on page 1902
–
"Align Now All but RF" on page 1904
–
"Align Now RF" on page 1906
–
"Align Now Expired" on page 1907
–
"Align Now Preselector" on page 1908
–
"Align Now All but RF Preselector" on page 1909
–
"Align Now RF Presel Only (20 Hz to 3.6 GHz)" on page 1909
–
"Align Now External Mixer" on page 1910
–
"Align Source" on page 1911
–
"Align Receiver" on page 1912
–
"Align Fast" on page 1912
–
"Align LO Leakage" on page 1913
–
"Align IF Cable" on page 1913
–
"Align RRH Amplitude" on page 1913
–
"Align LO Clock" on page 1914
–
"Align VXT Transceiver" on page 1915
–
"Align External Mixer Path" on page 1919
–
"Align Low Band" on page 1920
–
"Align High Band" on page 1920
4.6.2.1 Align Now All
In PXE, the key label is Align Now All (plus RF Presel 20 Hz – 3.6 GHz)
Immediately executes an alignment of all subsystems. The instrument stops any
measurement currently underway, performs the alignment, then restarts the
measurement from the beginning (similar to pressing the Restart key).
If an interfering user signal is present at the RF Input, the alignment is performed on
all subsystems except the RF. After completion, the Error Condition message “Align
RF skipped” is generated. In addition, the Error Condition message “Align Now, RF
Vector Modulation Analyzer Mode User's &Programmer's Reference 1902