Keysight Truevolt Series User Manual

*TST?
Performs a basic self-test of the instrument and returns a pass/fail indication. The TEST:ALL? self-test is
more comprehensive than the *TST? self-test.
Parameter Typical Return
(none) +0 (pass) or +1 (one or more tests failed)
Perform self-test:
*TST?
l The self-test takes just a few seconds to complete.
l If one or more tests fail, the query returns +1 and stores an error in the error queue. For a complete list-
ing of the error messages related to self-test failures, see Self-test Error Messages.
l Following the test, the instrument returns to the instrument state that existed before the self-test.
*WAI
Configures the instrument's output buffer to wait for all pending operations to complete before executing
any additional commands over the interface.
Parameter Typical Return
(none) (none)
Wait until all pending operations complete:
*WAI
l Configuration changes and measurements are considered pending operations. Therefore, *WAI causes
these changes to occur and complete.
SCPI Programming Reference
276
Keysight Truevolt Series Operating and Service Guide

Keysight Truevolt Series Specifications

General

Brand	Keysight
Model	Truevolt Series
Category	Measuring Instruments
Language	English