Command Summary
MMEMory:LOAD:PREFerences
MMEMory:STORe:PREFerences
MMEMory:LOAD:STATe
MMEMory:STORe:STATe
MMEMory:STATe:RECall:AUTO
MMEMory:STATe:RECall:SELect
MMEMory:STATe:VALid?
Folder and file formats
Many MMEMory commands refer to folders and files. These have specific structures, described below.
Format for a <folder>
l
The format for <folder> is "[[<drive>:]<path>]", where <drive> can be INTernal or USB, and <path> is
a folder path, and <filespec> specifies a subset of files.
l INTernal specifies the internal flash file system. USB specifies a front panel USB storage device.
l
If <drive> is specified, <path> is interpreted as an absolute folder path. Absolute paths begin with "\"
or "/" and start at the root folder of <drive>.
l
If <drive> is omitted, <path> is relative to the folder specified by MMEMory:CDIRectory. Relative
paths must NOT begin with \ or /.
l Folder and file names cannot contain the following characters: \ / : * ? " < > |
l
The <folder> parameter cannot exceed 240 characters.
l The specified folder must exist and cannot be marked as hidden or system. The exception is
MMEMory:MDIRectory, which creates a folder. For MMEMory:MDIRectory, all folder levels above the
new one must exist.
Format for a <file>
l
The format for a file name is "[[<drive>:]<path>]<file_name>", where <drive> can be INTernal or USB,
and <path>is a folder path.
l INTernal specifies the internal flash file system. USB specifies a front panel USB storage device.
l
If <drive> is specified, <path> is interpreted as an absolute folder path. Absolute paths begin with "\"
or "/" and start at the root folder of <drive>.
l
If <drive> is omitted, <path> is relative to the folder specified by MMEMory:CDIRectory. Relative
paths must NOT begin with \ or /.
l Folder and file names cannot contain the following characters: \ / : * ? " < > |
l The combination of folder and file name cannot exceed 240 characters.
Keysight Truevolt Series Operating and Service Guide
297
SCPI Programming Reference
To Next Page
Loading...
Need help?
General
