EasyManuals Logo

Keysight Truevolt Series User Manual

Keysight Truevolt Series
583 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #297 background imageLoading...
Page #297 background image
Mass Memory (MMEMory) and State Storage
States saved by the front panel can be accessed from remote, and vice versa. For example, configure the
instrument as desired and insert a USB drive into the front panel. Then enter the following commands. If
you do not have a USB drive change "USB:\" to "INT:\" to use the instrument's internal flash drive instead.
MMEMory:CDIRectory "USB:\"
MMEMory:MDIRectory "States"
MMEMory:STORe:STATE "USB:\States\State1"
To return to this state at any time:
MMEMory:LOAD:STATE "USB:\States\State1"
You can also recall a state file from the front panel by pressing [Utility] > Store/Recall.
MMEMory:LOAD:PREFerences <file>
MMEMory:STORe:PREFerences <file>
LOAD: Reboots the instrument and loads the nonvolatile I/O settings and user preferences from a file. The
specified file cannot be empty or marked as hidden or system.
STORE: Stores nonvolatile I/O settings and user preferences to a file. If the destination file exists, it will be
overwritten, unless marked as hidden or system.
When loading a preferences file that specifies a static IP address, be careful that this does not result in two
instruments with the same IP address on your LAN. This could cause LAN configuration errors on both
instruments.
Parameter Typical Return
Any valid file name
The .prf file extension is optional. If you do not include this extension, the instru-
ment firmware will automatically append it.
(none)
Stores the current nonvolatile I/O settings and user preferences into the specified file:
MMEM:STOR:PREF "INT:\MyPreferences"
Load nonvolatile I/O settings and user preferences from the specified file:
MMEM:LOAD:PREF "INT:\MyPreferences"
l See the State File/Preferences File table for a listing of the information contained in each file.
l The specified folder must exist and cannot be marked as hidden or system.
SCPI Programming Reference
298
Keysight Truevolt Series Operating and Service Guide

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keysight Truevolt Series and is the answer not in the manual?

Keysight Truevolt Series Specifications

General IconGeneral
BrandKeysight
ModelTruevolt Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals