Keysight Truevolt Series User Manual

STATus:OPERation[:EVENt]?
Returns the sum of the bits in the event register for the Standard Operation Register group. An event
register is a read-only register that latches events from the condition register. While an event bit is set, sub-
sequent events corresponding to that bit are ignored. The register bits are cleared when you read the
register.
Parameter Typical Return
(none) +512
Read the event register (bit 9 is set):
STAT:OPER:EVEN?
l Once a bit is set, it remains set until cleared by reading the event register or by sending *CLS (clear
status).
STATus:PRESet
Clears Questionable Data enable register and Standard Operation enable register.
Parameter Typical Return
(none) (none)
Clear enable register bits:
STAT:PRES
STATus:QUEStionable:CONDition?
Returns the sum of the bits in the condition register for the Questionable Data Register group. This register
is read-only; bits are not cleared when read.
A condition register continuously monitors the state of the instrument. Condition register bits are updated
in real time; they are neither latched nor buffered.
Parameter Typical Return
(none) +4096
Read the condition register (bit 12 is set):
STAT:QUES:COND?
l The condition register bits reflect the current condition. If a condition goes away, the corresponding
bit is cleared in the condition register.
SCPI Programming Reference
390
Keysight Truevolt Series Operating and Service Guide

Keysight Truevolt Series Specifications

General

Brand	Keysight
Model	Truevolt Series
Category	Measuring Instruments
Language	English