Kikusui TOS5301 - Page 11

TOS5300 11
3
Status indicators
READY: Lights in light blue when the TOS5300 Series is ready to perform a test. p.58
TEST: Lights in red when testing is being performed. p.58
PASS: Lights in green when a test passes. p.61
FAIL: Lights in yellow when a test fails. p.61
4
Display Displays the settings, measured values, and other information. p.36
5
MEMORY keys
Press these keys to display the settings that are saved to memory.
When test conditions or configuration items are being set, these keys correspond to
the menus displayed on the screen.
p.42 , p.88
MEMORY 1 key: Displays the settings saved to MEMORY 1.
MEMORY 2 key: Displays the settings saved to MEMORY 2.
MEMORY 3 key: Displays the settings saved to MEMORY 3.
RECALL key: Recalls settings from panel memory.
+ SHIFT key: Saves the current settings to panel memory.
1
6
START switch Starts testing. p.58 , p.78
7
STOP switch Stops testing and clears the current status. p.60
8
HIGH VOLTAGE
terminal
This terminal is for the high line of the tester output. p.26
9
LOW VOLTAGE terminal This terminal is for the low line of the tester output (with cable lock). p.26
10
Function key
Switches between test modes.
TOS5300: ACW key
TOS5301: ACW/ DCW key
TOS5302: ACW/ IR/ AUTO key
p.38 , p.41 ,
p.47 , p.49 ,
p.50
CONFIG key Displays the configuration setup screen. p.88
11
Rotary knob Changes settings. p.39
12
Screw hole Fasten a screw to this hole to fix the protection cover in place. —
13
SET key Press to select the voltage setting. p.39
LIMIT key Press to select the voltage limit setting. p.39
14
UPR/ LWR key
TOS5300/TOS5301: Press to select the upper and lower current limits.
TOS5302: Press to select the upper and lower current and resistance limits.
+SHIFT key: Turns the lower current limit on and off.
1
p.39
ON/ OFF key Turns the lower limit judgment feature on and off. p.39
15
REMOTE connector
Specialized connector for connecting the optional remote control box, RC01-TOS/
RC02-TOS, or the high voltage test probe, HP01A-TOS/HP02A-TOS.
p.16 , p.28
16
TEST key Press to select the test time (Test Time). p.39
ON/ OFF key Turns the test time (Test Time) on and off. p.39
17
USB port This is the USB interface. —
18
LOCAL key Switches between local mode and remote mode. —
SHIFT key Used to access the features that are written in blue. —
19
MORE key
Selects additional test condition settings.
ACW: Start voltage (Start Voltage), rise time (Rise Time), fall time (Fall Time), and
frequency (Frequency).
DCW: Start voltage (Start Voltage), rise time (Rise Time), and the time to wait before
making judgments (Wait Time).
IR: The time to wait before making judgments (Wait Time) and current detection
response speed (Response).
p.39 ,p.51
KEY LOCK key Locks panel key operations (settings and changes). p.40
20
POWER switch
Turns the power on [ ] and off [ ].
p.23
21
Protection cover Cover designed to prevent incorrect operation of the TOS5300 Series. p.22
1 This indicates an operation that requires you to press a key while holding down the SHIFT key.
No. Name Function
See