2MV
1-3-51
U073 Checking the scanner operation
Description
Simulates the scanner operation under the arbitrary conditions.
Purpose
To check the scanner operation. This is also done to check the accumulation of dust on the slit
glass.
Method
1. Press the start key.
2. Select the item to be operated.
Setting: [Scanner Motor]
1. Select [Scanner Motor].
2. Select the item.
3. Change the setting using the +/- keys or numeric keys.
Original sizes for each setting in SIZE
4. Press the start key. The setting is set.
5. Select [Execute].
6. Press the start key. Scanning starts under the selected conditions.
7. To stop operation, press the stop key.
Item No. Description
Display Description
Scanner Motor Scanner operation
Home Position Home position operation
Dust Check Dust adhesion check operation with lamp on
DP Reading DP scanning position operation
Display Operating conditions Setting range
Zoom Magnification 25 to 400 %
Size Original size See below.
Lamp On and off of the exposure lamp 0 (off) or 1 (on)
Setting Paper size Setting Paper size
5000 A4 5000 A5R
4300 B5 7800 Folio
5100 11" x 8
1/2" 10200 11" x 17"
10000 A3 9000 11" x 15"
8600 B4 8400 8
1/2" x 14"
7100 A4R 6600 8
1/2" x 11"
6100 B5R 5100 5
1/2" x 8 1/2"
To Next Page
Loading...
