2MV
1-3-117
U415 Adjusting the print position automatically
Description
Automatically adjusts timings at the print engine.
Adjustment for leading edge timing, center line and margin.
Purpose
Used to make respective auto adjustments for the print engine.
Method
1. Load A3/ledger paper.
2. Press the start key.
3. Select [Execute].
4. Press the start key. A test pattern is outputted
5. Set the output test pattern as the original.
6. Press the start key.
Automatically performs adjustment from the top to bottom cassettes.
7. When normally completed, [OK] is displayed.
If a problem occurs during auto adjustment, error code is displayed.
Error Codes
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Item No. Description
Codes Description
S001 Black band is not detected (main scanning direction far end)
S002 Black band is not detected (main scanning direction near end)
S003 Black band is not detected (auxiliary scanning direction leading edge)
S004 Black band is not detected (auxiliary scanning direction trailing edge)
S005 Auxiliary scanning direction skew error (1.5 mm or more)
S006 Main scanning direction skew error (1.5 mm or more)
S007 Original error (detection of reverse original paper)
S008 Original error (page mismatch)
SFFF Scanner other error
C101 Adjustment value error (main scanning direction magnification)
C102 Adjustment value error (auxiliary scanning direction magnification)
C103 Adjustment value error (leading edge timing)
C104 Adjustment value error (center line)
C105 Adjustment value error (B margin)
C106 Adjustment value error (A margin)
C107 Adjustment value error (C margin)
C108 Adjustment value error (D margin)
CFFF Controller other error
To Next Page
Loading...
