2MV
1-2-41
1-2-4 Installing the gigabit ethernet board (option)
Gigabit ethernet board installation requires the following parts:
Procedure
1. Press the power key on the operation
panel to off. Make sure that the power
indicator and the memory indicator are
off before turning off the main power
switch. And then unplug the power
cable from the wall outlet.
2. Remove two pins and then remove the
slot cover of the OPT2.
Figure 1-2-57
Parts Quantity Part.No.
Gigabit ethernet board 1
1505JV0UN0 (option)
Slot cover
Pin
Pin
OPT2
To Next Page
Loading...
