2MV-4
1-5-5
(2) Detaching and refitting the rear cover
Procedures
1. Remove the power cord.
If the document finisher is installed,
remove its interface connector.
2. Remove two screws of the DP interface
connector and then remove the DP
interface connector.
3. Remove eight screws.
4. Pull the rear cover upwards and then
release three hooks.
5. Remove the rear cover.
Figure 1-5-6
Screw
Screw
Screw
Screw
Rear cover
Hooks
Hook
DP interface
connector
Screws
Screw
Screw
Screws
To Next Page
Loading...
