2MV
1-3-90
U224 Supplement 2
Displaying start display
The pre-installed graphics file is displayed at power on or recovering from sleeping.
Graphics display on service call display
The pre-installed graphics file is displayed at a service call.
How to change the message
Entering #562 (4 letters) using the numeric keypad during a service call display will let service
call messages 1 and 2.
How to reset the message display
Reverting the maintenance mode will automatically reset the message to the previous.
Caution
The graphics file for start display must be opaque. (To avoid the background from overlapping at
recovering from sleeping.)
The total size of the files installable is approximately 1.8 MB.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
U243 Checking the operation of the DP motors
Description
Turns the motors or clutches in the DP on.
Purpose
To check the operation of the DP motors and clutches.
Method
1. Press the start key.
2. Select the item to be operated.
3. Press the start key. The operation starts.
4. To turn each motor off, press the stop key.
Completion
Press the stop key when operation stops. The screen for selecting a maintenance item No. is dis-
played.
Item No. Description
Display Description
Conv Motor DP paper feed motor (DPPFM) is turned on
Rev Motor DP switchback motor (DPSBM) is turned on
Feed Clutch DP paper feed clutch (DPPFCL) is turned on
Regist Clutch DP registration clutch (DPRCL) is turned on
To Next Page
Loading...
