2MV-1
1-5-6
(3) Detaching and refitting the inner tray
Procedures
1. Release the lock lever and then remove
the job separator tray.
ATTENTION: When refitting the Job
separator tray, are cautious of the posi-
tion of a paper guide.
Figure 1-5-7
2. Remove the rear cover.
(See page 1-5-5)
3. Remove the cassette.
(See page 1-5-9)
4. Open the front cover.
5. Remove four screws.
6. Release seven hooks A.
7. Pull the left lower cover upwards and
then release eight hooks B.
8. Remove the left lower cover.
Figure 1-5-8
Job separator tray
Lock lever
Paper guide
Screw
Screw
Hooks B
Screw
Screw
Hooks A
Hook A
Hooks B
Left lower
cover
To Next Page
Loading...
