2MV
1-5-47
12. Remove all connectors from the video
PWB.
13. Release three wire holders and three
edgings and remove the wires and the
FFC.
14. Remove nine screws and then remove
the controller box.
Figure 1-5-84
15. Remove all conectors from the engine
PWB.
16. Remove four screws and then remove
the engin PWB.
17. Check or replace the engine PWB and
refit all the removed parts.
CAUTION: When replacing the engine
PWB, remove the EEPROM (U15) from
the engine PWB that has been removed
and then reattach it to the new engine
PWB.
Figure 1-5-85
PWB connector
YC24
YC23
YC1
YC2
YC5
YC14
YC17
YC13
YC15
YC16
YC20
YC22
YC4
YC6
YC7
YC8
YC9
YC3
Screw
Screws
Screw
Wire holders
Screws
Video PWB
Screw
Controller box
Edgings
Screw
Screw
YC13
YC14
YC11
YC12
YC10
YC29
YC9
YC6
YC28
YC7
YC8
YC5
YC1
YC19
YC22
YC24
YC25
YC26
YC21
YC20
YC15
YC2
YC4
YC3
YC41
YC40
YC45
YC42
YC44
YC43
Screw
Screw
Screw
Screw
Engine PWB
PWB connector
To Next Page
Loading...
