2MV-9
2-4-4
Section
Maintenance
part/location
Periodic maintenance
(x1000 counts)
Points and cautions Page
Set
up
User
call
200 400
Image
Scaner
section
Contact glass CL CL CL CL: Slit glass for DP: Clean by dry
cloth or alcohol (attention: wet cloth
is strictly prohibited.) when inatalling
DP,clean with dry cloth.
Contact glass for putting the original
on: Dry cloth after cleaning with
alcohol (FACE SIDE)
Wipe the back side with dry cloth
after cleaning with alcohol only
when unusual image (line or stain)
appears. (BACK SIDE)
P.1-5-26
Mirror A/B/C
CL
CL: Airblow after dry cloth only
when unusual image(line) appears
-
ISU lens
CL
CL: Airblow after dry cloth only
when unusual image(line) appears
P.1-5-26
Exposure unit CH
RE
RE: Replace if there are image
problems
P.1-5-29
ISU rail
LU
Check abnormal noise and jitter.
LU: scanner rail grease PG-671(P/
N 60170000)
-
Original detection
switch
CH
CL
CL:Alcohol or dry cloth if there is
problem. (lighting part and light
reception part.)
-
ISU CH
RE
Replace if there are image prob-
lems
P.1-5-26
Section
Maintenance
part/location
Periodic maintenance
(x1000 counts)
Points and cautions Page
Set
up
User
call
200 400
Drive and
Other
section
Clutch
CH
RE
CH CH
CH: Check the copy registration and
paper feed condition on registration
and paper feed section
-
Sensor
CH CH CH
CH: Dry cloth or airblow if light
reception part of photo sensor is dirt
or paper dust
-
To Next Page
Loading...
