Kyocera TASKalfa 2550ci - Page 505

2MV-4
No. Content
Check procedure & check point
Remark 1 TASKalfa 2550ci
F37X
An error is detected at the
FAX management section
1) Format the HDD and check function. (U024 FULL formatting) (*1)
2) Execute the U021 Memory initializing to initialize the controller backup memory and
check function.
3) Execute the U671 Clear FAX back up data (FAX DIMM clear) and check function. (*3)
(Take cae of the received data since it is cleared)
4) Replace the FAX_DIMM and check function.
5) Replace the main board and check function.
6) Replace the HDD and check function. (*1)
7) Retrieve the USBLOG and contact the Service Administrative Division.
(*1) For the HDD standard model only.
(*3) For the models using the main PWB with the flash for the FAX data.
F14A,F14F:KUIO error
Main board (USB hub)
[Main-KUIO Interface]
Main board: YC8,YC9
Video board: YC13,YC14
F38X
An error is detected at the
Authentication/permit
management section
1) Format the HDD and check function. (U024 FULL formatting) (*1)
2) Execute the U021 Memory initializing to initialize the controller backup memory and
check function.
3) Replace the main board and check function.
4) Replace the HDD and check function. (*1)
5) Retrieve the USBLOG and contact the Service Administrative Division.
(*1) For the HDD standard model only.
F39X
An error is detected at the
KMAS control section
1) Check connection of the harness (KMAS - Main board) and connectors and check
function.
2) Format the HDD and check function. (U024 FULL formatting) (*1)
3) Execute the U021 Memory initializing to initialize the controller backup memory and
check function.
3) Replace the main board and check function.
4) Replace the HDD and check function. (*1)
5) Retrieve the USBLOG and contact the Service Administrative Division.
(*1) For the HDD standard model only.
[KMAS Interface]
Main board: YC7
F3AX
F3BX
F3CX
F3DX
F3EX
F3FX
F40X
F41X
F42X
F43X
F44X
F45
X
F46X
An error is detected at the
Print image process section
1) Replace the main board and check function.
2) Retrieve the USBLOG
(or retrieve the print capture data by case)
*The F46F is printer
process error. If it repeats
with a certain print data,
retrieve the capture data
and USBLOG.
An error is detected at the
Entity management section
1) Format the HDD and check function. (U024 FULL formatting) (*1)
2) Execute the U021 Memory initializing to initialize the controller backup memory and
check function.
3) Replace the main board and check function.
4) Replace the HDD and check function. (*1)
5) Retrieve the USBLOG and contact the Service Administrative Division.
(*1) For the HDD standard model only.
2-4-20