2MV
1-2-34
20. Pass the connector of the key counter
wire from Below through the aperture in
the controller box and then connect to
the connector (YC24) of the video
PWB.
21. Fix the key counter wire by using nine
wire saddle A.
Note: When a key counter electric wire
slackens, bundle and fix to X position.
Figure 1-2-47
22. Refit the hard disk using two screws.
23. Connect two connectors to the connec-
tor (YC1 and YC27) of main PWB.
24. Put the wire in the wire guide and then
fix it using four wire holders.
25. Fit the controller box cover using fifteen
screws.
26. Fit the ISU rear cover using two screws.
27. Fit the right upper cover.
Note: Pass the connector of the key
counter wire through the aperture (right
side) in the right upper cover.
Note: Be careful not to put a key
counter electric wire with the upper right
cover.
28. Fit the ISU right cover using two
screws.
Figure 1-2-48
Wire saddle A
Wire saddle A
Wire saddle A
Control box aperture
Connector
(YC24)
Key counter wire
X
Screw
Screw
Wire holder
Wire holder
Wire guide
Wire holder
Connector (YC27)
Connector (YC1)
Hard disk
To Next Page
Loading...
