LACO Technologies TITAN VERSA C - Remote I;O; Remote I;O Default Options

6 OPERATION
LACO Technologies TITAN VERSA Operations and Maintenance Manual 91
Remote I/O
Remote I/O If the Remote I/O module accessory is attached, select the Remote I/O option.
Next, press the various I/O option type buttons to configure the required I/O.
Below is a summary of the default I/O configurations.
Remote I/O Default Options
ID
Digital Inputs
Digital Outputs
Analog Outputs
0
Start / Stop
Reject 1
Mantissa
1
Sniff / Vac
Ready to Start
Exponent
2
Internal Cal
LD error
3
Zero
In final test mode
4
Inlet Vent
Calibrate Ack
5
Clear Error
Reject 2
6
Int Cal Check
Reject 3
7
Go to Ultra mode
Calibration active