LACO Technologies TITAN VERSA C - Product Configurations; Unpack from Shipping Box; Remove VERSA C Leak Detector; Remove VERSA T and L Leak Detector

3 TRANSPORT AND STORAGE
8 TITAN VERSA Operations and Maintenance Manual LACO Technologies
Product Configurations
The three product sizes are discussed in Configurations. Each configuration has unique
lifting needs summarized in Table 2 below.
Primary Lifting Methods by Configuration
Configuration
Primary Lifting Method
New Packaging
P/N:
Reusable
Packaging P/N:
VERSA C
(“Compact”)
Two-person lift with hands supporting
bottom of unit (see Section 3.1.3)
LMSA116490-1
LMSA5959 with
foam
VERSA L
(“Horizontal”)
Use lifting device (i.e. crane) or two-
person lift using installed lifting
hardware and strap (see Section 3.1.4
and 3.1.5)
LMSA116490-3
TV119209 with
foam
VERSA T
(“Tower”)
LMSA116490-2
TV119209 with
foam
Unpack from Shipping Box
Remove contents that have been stored on top of leak detector. Contents include:
• TITAN VERSA Quick Start Guide
• TITAN VERSA Operations and Maintenance Manual
• Tools and Replacements Box
• Lifting kit bag and replacement hardware
Remove VERSA C Leak Detector
The VERSA C (Compact) model does not include a lifting strap described in the sections
below. Remove the unit from packaging using the following process:
1. Remove foam panels from sides of leak detector.
2. Remove protective plastic from leak detector.
3. Using two individuals (one on each side), place hands on bottom of unit, lift unit,
and remove unit from packaging.
Remove VERSA T and L Leak Detector
1. Remove foam panels from sides of leak detector.
2. Remove protective plastic from leak detector.
3. Given the weight of the product, the TITAN VERSA should only be removed from
shipping in the following conditions:
o Personnel must be qualified and trained in handling heavy materials.
o Use either a lifting crane or a two-person lift to remove unit from packaging.
o Use the yellow lifting strap to remove leak detector. Be careful not to tip leak
detector more than 20 degrees.