5 INSTALLATION
LACO Technologies TITAN VERSA Operations and Maintenance Manual 21
Installation
The leak detector must be installed on a flat, horizontal surface, supported by its feet,
with the leak detector's inlet port on the top. Ensure the mounting surface is stable and
well-supported. Choose the location for setup according to the specifications of the
detector in Technical Data and Feature Locations and Dimensions.
Do not move the TITAN VERSA while in use. Wait five minutes after a full power
shutdown to move the unit.
WARNING: Danger from moisture and electricity
Moisture penetrating the device can lead to personal injury from electric
shock and to material damage from short circuits.
• Only operate the TITAN VERSA in a dry environment.
• Operate the TITAN VERSA away from sources of liquid and moisture.
• Position the device so that you can always reach the mains plug and
disconnect the device from the mains by unplugging the mains plug.
NOTICE: Material damage due to overheating
The device heats up during operation and can overheat without enough
ventilation.
• Ensure there is enough space for ventilation. Leave at least 20 cm of free
space on the sides of the leak detector, and at least 10 cm in the front
and rear.
• Keep heat sources away from the device.
• Do not expose the device to direct sunlight.
All wet pump units are shipped with vacuum pump oil in the pumps.
To Next Page
Loading...