Lantronix SLC 8000 User Manual

15: Command Reference
SLC™ 8000 Advanced Console Manager User Guide 370
Note: Drivers running in debug mode will generate copious output and for disk space
reasons should not be left running in debug mode for long periods of time.
set rpm edit
Syntax
set rpm edit <RPM Id or Name> <one or more parameters>
Parameters
name <New RPM Name>
outlets <# of Outlets>
ipaddr <IP Address>
port <TCP or Device Port>
login <RPM Admin Login>
rocommunity <SNMP Read-Only Community>
rwcommunity <SNMP Read-Write Community>
logstatus <disable|1-60 minutes>
snmptraps <enable|disable>
emailaddress <Email Address>
upslowbattery <shutdown|shutdownall|shutdownboth|allowfailure>
sdorder <disable|1-49>
powertoslc <enable|disable>
driveropts <Driver Options Override>
Description
Configure and control Remote Power Managers (RPMs), including PDUs and UPSes.
set rpm password
Syntax
set rpm password <RPM Id or Name>
Description
Set RPM administrative password.
show RPM
Syntax
show rpm [type <ups|pdu>]
[config <sdorder|notify>]
[device <RPM Name or Id> [data <raw|logs|envmon>]]
Note: The show rpm envmon command for RPM-configured ServerTech Serial/Network
Mode is not supported by NUT/Powerman.

Lantronix SLC 8000 Specifications

General

Rack mounting	Yes
Console port	RJ-45
Serial ports quantity	48
USB 2.0 ports quantity	2
AC input voltage	120-230 V
Power source type	AC
AC input frequency	50 - 60 Hz

Weight and Dimensions

Weight	5030 g
Dimensions (WxDxH)	436.9 x 304.8 x 43.18 mm