LeeBoy 8608 - Adjust Generator Belt; Beacon and Work Lights; Dielectric Grease

55
Maintenance
LeeBoy 8608 Commercial Paver 5-31
Adjust Generator BeltAdjust Generator Belt
Adjusting the generator belt every 250 hours (quarterly)
for optimum performance is a simple procedure. You
can access the generator via the left access panel.
To adjust the belt tension on the generator:
1. Slightly loosen the bolts on the generator plate.
(Figure 5-29)
2. Slightly tighten the generator mount bolt until you
have approximately 1/2 to 3/4 inches deection with
minimal force.
3. Retighten the bolts on the generator plate.
Generator
Plate
Bolt
Mount
Bolt
Figure 5-29. Generator Belt Adjustment
Beacon and Work LightsBeacon and Work Lights
Inspect lights for proper operation daily. If a light or
group of lights does not function:
• Check the fuse box panel for a blown fuse.
• Examine all visible wiring connections, ensuring they
are not frayed or damaged, and securely fastened.
• Check lighting mounts for proper ground.
• Inspect wiring harness for damage. If broken wires are
found, solder together and cover with a shrink-wrap
type of plastic covering (preferred) or electrician’s
tape to prevent contamination of the solder joint by
moisture.
If you make any repairs to the wiring harness, always
replace or repair the protective loom covering the
wiring to prevent future damage to the wiring harness.
Examine the routing of the harness and ensure it is not
subjected to excessive movement, which often causes
broken wiring.
Dielectric GreaseDielectric Grease
Dielectric grease is a nonconductive, insulating
compound applied to electrical connectors. When
applied correctly, a high-quality dielectric grease
displaces debris and moisture in the connector. The
proper application of dielectric grease lls any gaps
between pins or in the connector which prevents debris
and moisture from creating corrosion of the electrical
components.
Equipment damage can occur if using
low-quality, incompatible dielectric grease.
If not applied or incorrectly applied, corrosion can result
that causes rapid increase in resistance, intermittent
connections, overheating, and a variety of electrical
problems. Numerous electrical issues throughout the
machine can be avoided by the proper application and
use of dielectric grease.
Figure 5-30. Correct Application of Dielectric
Grease