LeeBoy 8608 - Safety Precautions

The safety messages that follow have DANGER level
hazards.
Power Lines HazardPower Lines Hazard
If your machine comes into contact with electric power
lines, observe the following:
• Stay in the operators seat.
• Warn other workers to stay away and do not touch any
control or any part of the machine.
• If contact can be broken, drive the machine away from
the danger zone.
• If contact cannot be broken, stay in the operators seat
until told that power is off.
• Failure to observe these directions could result in
electrocution or death.
Electrocution HazardElectrocution Hazard
Disconnect the battery before welding anywhere on the
machine.
Suffocation HazardSuffocation Hazard
Carbon monoxide poisoning is a serious
condition that occurs as a result of improper
ventilation.
• Never operate the internal combustion engine on this
machine in an enclosed area with poor ventilation.
Ensure proper ventilation to reduce risk of carbon
monoxide poisoning or death.
Exhaust HazardExhaust Hazard
All internal combustion engines create
carbon monoxide gas during operation and
special precautions are required to avoid
carbon monoxide poisoning:
• Never block windows, vents or other means of
ventilation.
• Always ensure that all connections are tightened to
specications after repair is made to the exhaust
system.
Safety Precautions
The safety messages that follow have CAUTION level
hazards.
Pre-Operation HazardPre-Operation Hazard
Read and understand this Operation Manual
before operating or servicing the engine to
ensure that safe operating practices and maintenance
procedures are followed.
• Never permit anyone to service or operate the
machine without proper training.
• Safety signs and labels are additional reminders for
safe operating and maintenance techniques.
• Contact LeeBoy or an authorized LeeBoy dealer for
additional training.
• Make sure you are aware of all laws and regulations
that are in effect for the location in which the paver is
operated.
• Make sure you have all necessary licenses to operate
the paver.
• Never operate a unit in need of repair.
• Ensure all covers are installed.
Poor Lighting HazardPoor Lighting Hazard
The work area must be well lit to ensure safe and proper
operation.
• Ensure that the work area is adequately illuminated.
• Always install wire cages on portable safety lights.
Tool HazardTool Hazard
Always use tools appropriate for the task
at hand and use the correct size tool for
loosening or tightening LeeBoy machine parts.
Safety
LeeBoy 8608 Commercial Paver1-4