LeeBoy 8608 - Weldment

WELDMENT
If the machine has been damaged or metal parts worn
due to extensive use, minor welding may be necessary
for repair. Welding is very dangerous. Only individuals
who are properly trained should weld in a dedicated
area away from others as even looking at ultraviolet light
from the ame can cause serious eye injury.
Welding hazards include toxic fumes, harmful dust,
light radiation, burns, combustion from sparks and the
potential for extensive damage to the eye. There is also
a danger of electric shock. If combustible or ammable
materials are nearby, the heat and sparks produced by
welding can cause res or explosions.
TURN THE BATTERY SWITCH OFF AND
DISCONNECT BATTERY TERMINALS BEFORE
WELDING ON THE MACHINE.
Electrical current can ignite re or cause an explosion,
therefore it is critical to turn off power to the machine. It
is also important to grind off the paint to ensure proper
ground on the area being welded.
DO NOT MAKE MODIFICATIONS TO THE MACHINE.
ONLY weld if needed for repair purposes. Weldment
modications to the machine can void your warranty.
Before welding on the machine:
PREPARE:
• Clear the area of any re hazards, ammable liquids
and solids, or any items that could catch on re.
• Ensure a re extinguisher is available in the work area.
• Hang welding blanket(s) around and underneath the
work area.
• Paint and rust should be removed from the welding
area to prevent arcing in other areas or components.
An indirect ground can cause arcing that will damage
machine components. Only connect the ground to
the component being welded. DO NOT connect the
ground to other bolted assemblies, wheels, bearings,
motors, tracks, torque hubs, etc.
DISCONNECT:
• Turn the master battery switch to the OFF position.
• Disconnect the battery positive and negative
terminals.
• Disconnect Plus 1 controller(s).
• Disconnect engine ECU(s) controller (if equipped).
• Disconnect engine DEF controller (if equipped).
• If machine has truck chassis: Disconnect the battery
positive and negative terminals and unplug the ECU(s)
for the engine, transmission and ABS systems if
equipped. Refer to the truck owner manual for any
other recommendations.
55
Maintenance
LeeBoy 8608 Commercial Paver 5-47