June 2018
144 Legrand PDU User Guide
Wireless Network Settings
If the device's cascading mode is set to 'Bridging' or its role is set to 'Slave' in the port forwarding mode,
the wireless settings will be disabled. See Setting the Cascading Mode (on page 150).
By default the wireless interface is disabled. You should enable it if wireless networking is wanted.
On the Network page, click the WIRELESS section to configure wireless and IPv4/IPv6 settings.
Interface Settings:
Field/setting Description
Enable Interface Enable or disable the wireless interface.
When disabled, the wireless networking fails.
Hardware State Check this field to ensure that the Legrand PDU
has detected a wireless USB LAN adapter. If not,
verify whether the USB LAN adapter is firmly
connected or whether it is supported.
SSID Type the name of the wireless access point (AP).
Force AP BSSID If the BSSID is available, select this checkbox.
BSSID Type the MAC address of an access point.
Enable High
Throughput
(802.11n)
Enable or disable 802.11n protocol.
Authentication Select an authentication method.
No Authentication: No authentication data is
required.
PSK: A Pre-Shared Key is required.
EAP - PEAP: Use Protected Extensible
Authentication Protocol. Only MSCHAPv2 is
supported. Enter required authentication data
in the fields that appear.
Pre-Shared Key
This field appears only when PSK is selected.
Type the PSK string.
Identity
This field appears only when 'EAP - PEAP' is
selected.
Type your user name.
Password
This field appears only when 'EAP - PEAP' is
selected.
Type your password.
To Next Page
Loading...
