June 2018
Legrand PDU User Guide 383
Enabling or Disabling Load Shedding
This section applies to outlet-switching capable models only.
This command determines whether to enter or exit from the load shedding mode.
# loadshedding <option>
After performing the above command, Legrand PDU prompts you to confirm the operation. Press y to
confirm or n to abort the operation.
To skip the confirmation step, you can add the "/y" parameter to the end of the command so that the
operation is executed immediately.
# loadshedding <option> /y
Variables:
<option> is one of the options: enable or disable.
Option Description
start Enter the load shedding mode.
stop Quit the load shedding mode.
Example
The following command has the Legrand PDU enter the load shedding mode.
config:# loadshedding start
Power Control Operations
This section applies to outlet-switching capable models only.
Outlets on the Legrand PDU can be turned on or off or power cycled through the CLI.
Besides, you can cancel the power-on process while the Legrand PDU is powering on ALL outlets.
You must perform this operation in the administrator mode. See Different CLI Modes and Prompts (on
page 271).
To Next Page
Loading...
