June 2018
220 Legrand PDU User Guide
Important: Although it is possible to selectively enable/disable logging for individual sensors on the Legrand
PDU, it is NOT recommended to do so.
Configuring Data Push Settings
You can push the sensor log to a remote server for data synchronization. The data will be sent in JSON
format using HTTP POST requests. You need to set up the destination and authentication for data push on
the Legrand PDU.
After configuring the destination and authentication settings, do either or both of the following:
To perform the data push after the occurrence of a certain event, create the data push action and assign
it to an event rule.
To push the data at a regular interval, schedule the data push action.
See Event Rules and Actions (on page 184).
To configur
e
data push settings:
1. Choose Device Settings > Data Push.
2. To specify a destination, click
.
3. Do the following to set up the URL field.
a. Click
to select http or https.
b. Type the URL or host name in the accompanying text box.
4. If selecting https, a CA certificate is required for making the connection. Click
to install it.
Then you can:
Click Show to view the certificate's content.
Click Remove to delete the installed certificate if it is inappropriate.
Note: If the required certificate file is a chain of certificates, and you are not sure about the requirements
of a certificate chain, see TLS Certificate Chain (on page 490).
5. If the destination server requires authentication, select the Use Authentication checkbox, and enter the
following data.
User name
Password
6. In the Entry Type field, determine the data that will be transmitted.
Asset management tag list: Transmit the information of the specified asset strip(s), including the
general status of the specified strip(s) and a list of asset tags. The asset tags list also includes those
on blade extension strips, if any.
Asset management log: Transmit the log of all asset strips, which is generated when there are
changes made to asset tags and asset strips, including asset tag connection or disconnection
events.
Sensor log: Transmit the record of all logged sensors, including their sensor readings and/or status.
Logged sensors refer to all internal and/or environmental sensors/actuators that you have selected
on the Data Logging page. See Setting Data Logging (on page 219).
Note: Leg
ran
d PDU does NOT support asset management strips so you can ignore asset
management-related data.
7. Click Create.
8. Repeat the same steps for additional destinations.
To modify or delete data push settings:
1. On the Data Push page, click the one you want in the list.
2. Perform either action below.
To Next Page
Loading...
