LEGRAND PDU - Role Configuration Commands

June 2018
Legrand PDU User Guide 351
config:# user defaultpreferences preferredTemperatureUnit F preferredLengthUnit feet
preferredPressureUnit psi
Results:
 The default temperature unit is set to Fahrenheit.
 The default length unit is set to feet.
 The default pressure unit is set to psi.
Role Configuration Commands
A role configuration command begins with role.
Creating a Role
This command creates a new role, with a list of semicolon-separated privileges assigned to the role.
config:# role create <name> <privilege1>;<privilege2>;<privilege3>...
If a specific privilege contains any arguments, that privilege should be followed by a colon and the
argument(s).
config:# role create <name> <privilege1>:<argument1>,<argument2>...;
<privilege2>:<argument1>,<argument2>...;
<privilege3>:<argument1>,<argument2>...;
...
Variables:
 <name> is a string comprising up to 32 ASCII printable characters.
 <privilege1>, <privilege2>, <privilege3> and the like are names of the privileges assigned to the role.
Separate each privilege with a semi-colon. See All Privileges (on page 351).
 <a
rgument1
>, <argument2> and the like are arguments set for a particular privilege. Separate a privilege
and its argument(s) with a colon, and separate arguments with a comma if there are more than one
argument for a privilege.
All Privileges
This table lists all privileges. Note that available privileges vary according to the model you purchased. For
example, a PDU without the outlet switching function does not have the privilege "switchOutlet."
Privilege Description
acknowledgeAlarms Acknowledge Alarms
adminPrivilege Administrator Privileges
changeAssetStripConfiguration Change Asset Strip
Configuration
changeAuthSettings Change Authentication Settings