LEGRAND PDU - A Note about Enabling Thresholds

June 2018
268 Legrand PDU User Guide
Configuring NTP Server Settings
Using SNMP, you can change the following NTP server-related settings in the unitConfigurationTable:
 Enable or disable synchronization of the device's date and time with NTP servers
(synchronizeWithNTPServer)
 Enable or disable the use of DHCP-assigned NTP servers if synchronization with NTP servers is
enabled (useDHCPProvidedNTPServer)
 Manually assign the primary NTP server if the use of DHCP-assigned NTP servers is disabled
(firstNTPServerAddressType and firstNTPServerAddress)
 Manually assign the secondary NTP server (optional) (secondNTPServerAddressType and
secondNTPServerAddress)
Tip: To specify the time zone, use the CLI or web interface instead. For the CLI, see Setting the Time Zone
(on page 321). For the web interface, see Setting the Date and Time (on page 182).
When using the SNMP SET command to specify or change NTP servers, it is required that both the NTP
server's address type and address be set in the command line simultaneously.
For example, the SNMP command to change the primary NTP server's address from IPv4 (192.168.84.84) to
host name looks similar to the following:
snmpset -v2c -c private 192.168.84.84 firstNTPServerAddressType = dns
firstNTPServerAddress = "angu.pep.com"
A Note about Enabling Thresholds
When enabling previously-disabled thresholds via SNMP, make sure you set a correct value for all
thresholds that are supposed to be enabled prior to actually enabling them. Otherwise, you may get an error
message.