LEGRAND PDU - Page 321

June 2018
Legrand PDU User Guide 321
Customizing the Date and Time
If intending to manually configure the date and time, use the following CLI commands to specify them.
Note: You shall set the time configuration method to "manual" prior to customizing the date and time. See
Determining the Time Setup Method (on page 320).
 Assign the date:
config:# time set date <yyyy-mm-dd>
 Assign the time:
config:# time set time <hh:mm:ss>
Variables:
Variable Description
<yyyy-mm-dd> Type the date in the format of yyyy-mm-dd.
For example, type 2015-11-30 for November 30,
2015.
<hh:mm:ss> Type the time in the format of hh:mm:ss in the
24-hour format.
For example, type 13:50:20 for 1:50:20 pm.
Setting the Time Zone
The CLI has a list of time zones to configure the date and time for the Legrand PDU.
config:# time zone
After a list of time zones is displayed, type the index number of the time zone or press Enter to cancel.
Example
 To set the time zone:
1. Type the time zone command as shown below and press Enter.
config:# time zone
2. The system shows a list of time zones. Type the index number of the desired time zone and press Enter.
3. Type apply for the selected time zone to take effect.