LEGRAND PDU - Overcurrent Protector Sensor Threshold Information

June 2018
Legrand PDU User Guide 283
Displayed information:
 Without the parameter "details," only the reading, state, threshold, deassertion hysteresis and assertion
timeout settings of the specified inlet pole sensor are displayed.
 With the parameter "details," more sensor information is displayed, including resolution and range.
 If the requested sensor type is not supported, the "Sensor is not available" message is displayed.
 Additional sensors supported by Legrand PDUs:
The CLI command(s) listed above can be also applied to the following sensors. Note that the measurement
unit of current values in CLI is A, not mA.
Sensor type Description
peakCurrent Peak current sensor
reactivePower Reactive power sensor
displacementPowerFactor Displacement power factor sensor
phaseAngle Inlet phase angle sensor
Overcurrent Protector Sensor Threshold Information
This command is only available for models with overcurrent protectors for protecting outlets.
This command syntax shows the specified overcurrent protector sensor's threshold-related information.
# show sensor ocp <n> <sensor type>
To show detailed information, add the parameter "details" to the end of the command.
# show sensor ocp <n> <sensor type> details
Variables:
 <n> is the number of the overcurrent protector whose sensors you want to query.
 <sensor type> is one of the following sensor types:
Sensor type Description
current Current sensor
Displayed information:
 Without the parameter "details," only the reading, state, threshold, deassertion hysteresis and assertion
timeout settings of the specified overcurrent protector sensor are displayed.
 With the parameter "details," more sensor information is displayed, including resolution and range.