June 2018
Legrand PDU User Guide 275
Network Interface Settings
This command shows the specified network interface's information which is NOT related to IP configuration.
For example, the Ethernet port's LAN interface speed and duplex mode, or the wireless interface's SSID
parameter and authentication protocol.
# show network interface <ETH>
Variables:
<ETH> is one of the network interfaces: ETH1, ETH2, WIRELESS, or BRIDGE. Note that you must
choose/configure the bridge interface if your Legrand PDU is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE interface function. The IP parameters
of ETH1, ETH2 and WIRELESS interfaces do NOT function.
Interface Description
eth1
Show the ETH1 interface's non-IP settings.
eth2
Show the ETH2 interface's non-IP settings.
wireless Show the WIRELESS interface's non-IP settings.
bridge Show the BRIDGE interface's non-IP settings.
all Show the non-IP settings of all interfaces.
Tip: You can also type the command without
adding this option "all" to get the same data. That
is, show network interface.
Network Service Settings
This command shows the network service settings only, including the Telnet setting, TCP ports for HTTP,
HTTPS, SSH and Modbus/TCP services, and SNMP settings.
# show network services <option>
Variables:
<option> is one of the options: all, http, https, telnet, ssh, snmp, modbus and zeroconfig.
Option Description
all Displays the settings of all network services,
including HTTP, HTTPS, Telnet, SSH and SNMP.
Tip: You can also type the command without
adding this option "all" to get the same data.
http Only displays the TCP port for the HTTP service.
https Only displays the TCP port for the HTTPS service.
telnet Only displays the settings of the Telnet service.
ssh Only displays the settings of the SSH service.
To Next Page
