LEGRAND PDU - Page 300

June 2018
300 Legrand PDU User Guide
Setting the IPv4 Configuration Mode
This command determines the IP configuration mode.
config:# network ipv4 interface <ETH> configMethod <mode>
Variables:
 <ETH> is one of the network interfaces: ETH1, ETH2, WIRELESS, or BRIDGE. Note that you must
choose/configure the bridge interface if your Legrand PDU is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE interface function. The IP parameters
of ETH1, ETH2 and WIRELESS interfaces do NOT function.
Interface Description
eth1 Determine the IPv4 configuration mode of the
ETH1 interface (wired networking).
eth2 Determine the IPv4 configuration mode of the
ETH2 interface (wired networking).
wireless Determine the IPv4 configuration mode of the
WIRELESS interface (that is, wireless
networking).
bridge Determine the IPv4 configuration mode of the
BRIDGE interface (that is, bridging mode).
 <mode> is one of the modes: dhcp or static.
Mode Description
dhcp The IPv4 configuration mode is set to DHCP.
static The IPv4 configuration mode is set to static IP
address.
Setting the IPv4 Preferred Host Name
After selecting DHCP as the IPv4 configuration mode, you can specify the preferred host name, which is
optional. The following is the command:
config:# network ipv4 interface <ETH> preferredHostName <name>
Variables:
 <ETH> is one of the network interfaces: ETH1, ETH2, WIRELESS, or BRIDGE. Note that you must
choose/configure the bridge interface if your Legrand PDU is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE interface function. The IP parameters
of ETH1, ETH2 and WIRELESS interfaces do NOT function.
Interface Description
eth1 Determine the IPv4 preferred host name of the
ETH1 interface (that is, wired networking).