LEGRAND PDU - Page 333

June 2018
Legrand PDU User Guide 333
config:# security strongPasswords enforceAtLeastOneSpecialCharacter <option>
Variables:
 <option> is one of the options: enable or disable.
Option Description
enable At least one special character is required.
disable No special character is required.
Maximum Password History
This command determines the number of previous passwords that CANNOT be repeated when changing the
password.
config:# security strongPasswords passwordHistoryDepth <value>
Variables:
 <value> is an integer between 1 and 12.
Role-Based Access Control
In addition to firewall access control based on IP addresses, you can configure other access control rules
that are based on both IP addresses and users' roles.
 An IPv4 role-based access control command begins with security roleBasedAccessControl ipv4.
 An IPv6 role-based access control command begins with security roleBasedAccessControl ipv6.
Modifying Role-Based Access Control Parameters
There are different commands for modifying role-based access control parameters.
 IPv4 commands
 Enable or disable the IPv4 role-based access control feature:
config:# security roleBasedAccessControl ipv4 enabled <option>
 Determine the IPv4 role-based access control policy:
config:# security roleBasedAccessControl ipv4 defaultPolicy <policy>
 IPv6 commands
 Enable or disable the IPv6 role-based access control feature:
config:# security roleBasedAccessControl ipv6 enabled <option>
 Determine the IPv6 role-based access control policy: