LEGRAND PDU - Page 354

June 2018
354 Legrand PDU User Guide
config:# role modify <name> addPrivileges
<privilege1>:<argument1>,<argument2>...;
<privilege2>:<argument1>,<argument2>...;
<privilege3>:<argument1>,<argument2>...;
...
Variables:
 <name> is a string comprising up to 32 ASCII printable characters.
 <privilege1>, <privilege2>, <privilege3> and the like are names of the privileges assigned to the role.
Separate each privilege with a semi-colon. See All Privileges (on page 351).
 <a
rgum
ent1
>, <argument2> and the like are arguments set for a particular privilege. Separate a privilege
and its argument(s) with a colon, and separate arguments with a comma if there are more than one
argument for a privilege.
 Remove specific privileges from a role:
config:# role modify <name> removePrivileges
<privilege1>;<privilege2>;<privilege3>...
If a specific privilege contains any arguments, add a colon and the argument(s) after that privilege.
config:# role modify <name> removePrivileges
<privilege1>:<argument1>,<argument2>...;
<privilege2>:<argument1>,<argument2>...;
<privilege3>:<argument1>,<argument2>...;
...
Note: When removing privileges from a role, make sure the specified privileges and arguments (if any)
exactly match those assigned to the role. Otherwise, the command fails to remove specified privileges that
are not available.
Variables:
 <name> is a string comprising up to 32 ASCII printable characters.
 <privilege1>, <privilege2>, <privilege3> and the like are names of the privileges assigned to the role.
Separate each privilege with a semi-colon. See All Privileges (on page 351).
 <argument1
>, <argument2> and the like are arguments set for a particular privilege. Separate a privilege
and its argument(s) with a colon, and separate arguments with a comma if there are more than one
argument for a privilege.
Deleting a Role
This command deletes an existing role.
config:# role delete <name>