LEGRAND PDU - Page 359

June 2018
Legrand PDU User Guide 359
config:# authentication ldap add op-ldap.raritan.com 389 openldap none
authenticatedBind cn=Manager,dc=raritan,dc=com uid inetOrgPerson
bindDN user@raritan.com
b. The system prompts you to specify the bind DN password.
c. Type the password and press Enter.
d. Re-type the same password.
Copying an Existing Server's Settings
If the server that you will add completely shares the same settings with any server that has been configured,
use the following command.
 Add an LDAP server by copying an existing server's settings:
config:# authentication ldap addClone <server_num> <host>
Variables:
 <host> is the IP address or host name of the LDAP server.
 <server_num> is the sequential number of the specified server shown on the server list of the Legrand
PDU. See Authentication Settings (on page 286).
Modifying an Existing LDAP Server
You can modify one or multiple parameters of an existing LDAP server, such as its IP address, TCP port
number, Base DN and so on. Besides, you can also change the priority or sequence of existing LDAP
servers in the server list.
 Command syntax:
A command to modify an existing LDAP server's settings looks like the following:
config:#
authentication ldap modify <server_num> "parameters"
Variables:
 <server_num> is the sequential number of the specified server in the LDAP server list.
 Replace "parameters" with one or multiple commands in the following table, depending on which
parameter(s) you want to modify.
 A list of "parameters":