LEGRAND PDU - Page 375

June 2018
Legrand PDU User Guide 375
Example 2 - Warning Thresholds for Inlet Sensors
The following command sets both the Upper Warning and Lower Warning thresholds for the inlet 1 RMS
current.
config:# sensor inlet 1 current upperWarning 20 lowerWarning 12
Results:
 The Upper Warning threshold for the inlet 1 RMS current is set to 20A. It also enables the upper warning
threshold if this threshold has not been enabled yet.
 The Lower Warning threshold for the inlet 1 RMS current is set to 12A. It also enables the lower warning
threshold if this threshold has not been enabled yet.
Example 3 - Upper Thresholds for Overcurrent Protector Sensors
The following command sets both the Upper Critical and Upper Warning thresholds for the 2nd overcurrent
protector.
config:# sensor ocp 2 current upperWarning enable upperCritical 16
Results:
 The Upper Critical threshold for the 2nd overcurrent protector's RMS current is set to 16A. It also
enables the upper critical threshold if this threshold has not been enabled yet.
 The Upper Warning threshold for the 2nd overcurrent protector's RMS current is enabled.