June 2018
430 Legrand PDU User Guide
2. Launch a terminal emulation program such as HyperTerminal, Kermit, or PuTTY, and open a window on
the Legrand PDU. For information on the serial port configuration, see Step 2 of Initial Network
Configuration via CLI (on page 486).
3.
Log in to the CLI by typing the user
name "admin" and its password.
4. After the # system prompt appears, type either of the following commands and press Enter.
# reset factorydefaults
-- OR --
# reset factorydefaults /y
5. If you entered the command without "/y" in Step 4, a message appears prompting you to confirm the
operation. Type y to confirm the reset.
6. Wait until the Username prompt appears, indicating the reset is complete.
To reset to factory defaults without logging in to the CLI:
The Legrand PDU provides an easier way to reset the product to factory defaults in the CLI prior to login.
1. Connect to the Legrand PDU and launch a terminal emulation program as described in the above
procedure.
2. At the Username prompt in the CLI, type "factorydefaults" and press Enter.
Username: factorydefaults
3. Type y on a confirmation message to perform the reset.
To Next Page
Loading...
