Figure 232. Installing the protective covers
After you finish
1. Install a replacement unit. See “Install an SXM GPU” on page 299.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install an SXM GPU
Follow instructions in this section to install a GPU.
About this task
Important: Removing and installing this component requires trained technicians. Do not attempt to remove
or install it without proper training.
Note: Make sure you have an alcohol cleaning pad available.
Attention:
• Read “Installation Guidelines” on page 121 and “Safety inspection checklist” on page 122 to ensure that
you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Prepare the following screwdrivers to ensure you can install and remove the corresponding screws properly
Table 24. Torque screwdriver type list
Torque screwdriver type list
Screw type
PH 2 head screwdriver Philips #2
Torx 10 screwdriver Torx T10 screw
The following illustration shows the GPU numbering.
Chapter 4. Hardware replacement procedures 299
To Next Page
Loading...
