Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 55
8400 HighLine | Parameter setting & configuration
Commissioning
Commissioning the "Table positioning" TA using the »Engineer«
11. Set homing
You can find detailed information on the "Referencing" (homing) operating mode in the
chapter entitled "Basic drive functions", subchapter "Homing
". ( 395)
Go to the Application parameters tab.
Click on Signal flow button.
Click on button for referencing in the "MotionControlKernel" block.
efesotomasyon.com - Lenze
To Next Page
Loading...
