Lenze 8600 series - Language; Display of Actual Valuesact. Value; Switch-On Display; Identification

8.2 Language
Under code CO98 you tan select the language of the display texts.
The Standard setting is German.
Code
t
Name Parameter (Factory setting is printed in bofd) Acceptance
CO98 Language -O- German SH + PRG
-l- English
-2- French
8.3
Display of actual valuesAct. value
Under Codes CO50 to CO54 you tan read different atiual values.
-
Act. value
Output frequency
Act. value of PI controller
Motor voltage
DG bus voltage
Motor current
Display
absolute in Hz
with Cl72 = -O-: related to fdmax
with Cl72 = -1-: absolute in Hz
absolute in V,H
absolute in V
absolute in Aeti
8.4 Switch-on display
If you connect the controller to the mains, the output frequency is
shown as the first display (CO50). If you want to set another
information as switch-on display, enter the corresponding code
number under CO04.
Code
E
Name
CO04 Switch-on
display
Parameter (Factory setting is prlnted in bold)
xxx Code number for display after mains
connection
Acceptance
SH + PRG
8.5
Identification
On the display of the keypad you tan see which Software version is
loaded in the controller. For this, select code CO99.
If you work with LECOM, you tan see the controller type under
co93.
P
0
(d
G
i
-.
3
(d
101