Lenze 8600 series - Applications with Medium Overload, Peak Torque up to 135 % of the Rated Motor Torque

-
3.3 Applications with medium overload,
peak torque up to 135 % of the rated motor torque
- For applications where only a small starting and
overload torque are necessary (e.g. Ventilators,
w-w+
-
The controller provides 110% of the rated torque for
a maximum of 30s.
For cyclic overload, the ratio overload to cycle time
must not exceed 0.1.
- For this application, the monitoring of the output
current is set to Operation with maximum power
using the Codes Cl 19 and Cl20 (see page 82 )
-
Please note that a maximum ambient temperature
of 40°C is permissible.
M
MN
10control
EVF8606-E-V009
EVF8614-E-V009
l These data are valid for a maximum ambient temperature of 30°C.
x
Lenze
21