Lenze 8600 series - Basic Parameter Setting; Changing Parameters

2 Basic Parameter setting
Programming of the frequency controller enables the drive to be
adapted to your application. The possible settings are arranged in
Codes, which are numbered in ascending Order and statt with the
letter “C”. Esch code provides one Parameter which tan be
selected according to the application.
-
Parameters tan be absolute or relative values of a physical unit
(e.g. 50Hz or 50% related to fdmax) or numerical Codes giving
certain Status information (e.g. -O- = controller inhibited, -1-
controller enabled).
In cases where the Parameters represent values of physical units,
it is possible that the increment varies.
Example: The maximum field frequency tan be set in increments
of 0.1 Hz up to 1 OOHz, and in increments of 1 Hz from 1 OOHz
upwards.
In some Codes, Parameters tan only be read but not changed.
In the factory setting, only those Codes are displayed which are
necessary for the most common applications. For activation of the
extended code set see page 100.
2.1
Changing Parameters
Esch code has a factory set Parameter which tan be changed.
There are three different ways of selecting another Parameter,
depending on the Code:
Direct acceptance
The controller immediately accepts the new Parameter, i.e. while
you Change it using the UP or DOWN keys. This is possible even
when the drive is running.
Parameters which are immediately accepted are marked with ON-
LINE in the following programming tables.
Example:
Under CO50, the controller Shows the momentary field frequency in
Hz. You want to set a maximum field frequency (CO1 1) of 60Hz.
56