Lenze 8600 series - Display Functions; Code Set

C :ode
C Zl20
lame
‘unction for
319
Parameter (Factoty setting is printed in bold)
ForC119=-0-.-l-
.o- Monitoring not active
-l- Monitoring active, sets trip
-2- Monitoring active, sets warning
ForC119=-1%
-Cl-
Rated power for temperature range up
to 50°C
-l- Increased power for temperature
range up to 45°C
-2- Maximum power for temperature
range up to 40°C
kceptancc
:H + PRG
8 Display functions
8.1 Code set
All Codes in the controller are arranged in different code Sets. With
factory setting, the Standard code set is activated. It contains all
Codes which are required for the most common applications.
By selecting the extended code set under code COOO, the display of
the keypad also Shows those Codes which are suitable for special
applications.
There is also a Service code set which is not accessible in general.
Password
If you want to protect your Parameter settings from non-authorized
access you tan enter a password in the form of a three-digit
number. By defining a password, the Parameters of the Standard
code set tan only be read, but not changed when the password is
not entered. The Parameters of the extended code set tan neither
be read nor changed.
First enter the password under CO94 and then set code CO00 to
“Standard code set read only”. After this, the setting of code CO00
tan only be changed when the programmed password is entered.
Code Name Parameter (Factory setting is printed in bold)
Acceptance
CO00 Code set -o- Standard code set read only
SH + PRG
-l- Standard code set
-2- Extended code set
-9-
Service code set
C094’ User password 0 0
(11
999 SH + PRG
INFO: 000 = No password request under CO00
* extended code set
100 lenze